How does the filter system connect to the biofuel stove?

Step 1: Connect the filter system

Connect the filter system first. The UV filter has already been installed by us, so you don't have to do that yourself.

Step 2: Install and connect the biofuel stove

Place the heater on the right side of the filter box. Connect the two hoses from the box to the black connections of the heater.
👉 Check that the rubber rings are present to prevent leakage. Tighten the swivels firmly by hand.

Step 3: Connect Power

Insert the plug through the filter box at the bottom and connect it to the socket in the box.

Step 4: Fill the diesel tank

The red diesel tank is already connected to the heater. Fill it with fuel and open the tap (found behind the door at the bottom of the stove).

Step 5: Turn on the system

Make sure the hot tub is filled with water before turning on the heater. Then power both the filter system, the UV filter and the heater.
⚠️ Important: The heater must always run at the same time as the filter system to prevent overheating.

‍