How do you connect the filter system to the hot tub?

Connecting the glass filter system

‍Step 1: Preparing the UV filter

Before the UV filter can be connected to the filter system, the lamp must first be placed in the housing. The video below explains these steps.

Step 2: Install the filter system

Place the filter system where the two hoses protrude from the hot tub. Connect the bottom black swivel that comes out of the hot tub to the filter pump as shown in the video.

Then install the UV filter by attaching both blue swivels, make sure they are tightened tightly. Make sure that the filter plug is at the bottom.

Step 3: Electrical connections

Plug the UV filter and filter pump into the power strip and only turn on the power strip when the hot tub is filled with water.

PAY ATTENTION! Set up the pump never on if the hot tub is not fully filled with water, this can cause immediate damage.

PAY ATTENTION! Place the handle on the filter head never in a different position while the filter pump is running, this may cause irreparable damage to the filter head.

Please note that both devices are switched on or off at the same time, if the UV filter is on without the filter pump on, this can cause damage to the lamp.

👉 Your filter system is now installed and ready to use!